Limitations On Use - Surewerx JACKSON WH70 BH3 Mode D'emploi

2. Hold the protection lens with your thumb and middle finger on the side extensions
along the indents in the helmet shell intended for your fingers. Press on the
protection lens to slightly bend it and remove it from the holder slots (2.).
3. Insert a new protection lens and close the cover as described in the previous
section, under points 3 and 4.
E.1
Figure
During assembly of the helmet and welding filter, or during the replacement of
the protection lens, make sure that all parts are firmly in place thus preventing
any light from entering the helmet. Should there still be any light entering,
repeat the procedure until the problem is eliminated, otherwise the helmet must
not be used for welding. Before placing any new protection lens always remove
the protection layers from both sides.
WH70 BH3 Air HELMET ASSEMBLY
®
/ WH70 BH3 Air - version of WH70 BH3
®
air supply system for combination with certified Airmax set /
If you have purchased the WH70 BH3
integrated air supply system, the helmet will be additionaly equiped with
integrated airduct, hose connector and air grill. JACKSON SAFETY
except responsibility for the results of a service performed by anyone other
than a JACKSON SAFETY
instructions may invalidate the warranty.

LIMITATIONS ON USE

1. Material of the hood can cause allergic reactions to a sensitive person.
2. Do not use tempered mineral filters without suitable protection foils.
3. The welding arc damages unprotected eyes!
4. The welding arc may burn unprotected skin!
5. Pay attention to checking the product before use. Do not use, if any part of the
system is damaged.
6. Do not put the welding hood on hot surface.
7. Use only within the temperature range of -5°C to +55°C.
8. Never use the hood in the following environments and under the following
conditions:
• If oxygen concentration in the environment is lower than 17 %.
• In oxygen-enriched environments.
• In explosive ambience.
• In environments where the user lacks knowledge about the kind of dangerous
substance and its concentration.
• In environments representing an immediate threat to the life and health.
• If you are not sure, that shade number of your welding filter lens is suitable for your
work.
• Replace protection filter immediately, if it is damaged, or if spatter or scratches
reduce vision.
• The hood does not protect against hard shocks, explosions or corrosive substances.
9. Move to a secure location and take appropriate measures when any of the following
problems occur while using the hood:
• If you feel significant increase of breathing resistance or any other problems with
breathing.
• If you experience stench or irritation or an unpleasant taste while breathing.
• If you feel unwell or if you experience nausea.
10. Use certified original filters designed for your powered air purifying respirator only.
Replace filters every time you detect change of odour in supplied air from the
respirator.
11. Filters designed for capturing solid and liquid particles (particle filters) do not
protect the user against any gases. Filters designed for capturing gases do not
protect the user against any particles. In the workplace contaminated with both
types of pollution, combined filters must be used.
6
helmet with integrated
®
helmet in a combination with the
®
authorised service agent. Failure to follow this
®
F
Figure
does not
®