MBM FTG74A Manuel D'installation Et D'utilisation page 42

ghly clean all the inside and outside
parts of the appliance.
Wait for the temperature of the
appliance and all its parts to
cool off, so that the operator is
not burnt.
Do not use pressurised direct
water or steam cleaners jets for
cleaning operations
DAILY CLEANING
Remove moving parts
if present (e.g. splash-
guard). Use a stan-
dard sprayer to apply
the liquid detergent on
the whole surface of the hob and,
using a non-abrasive sponge, clean
the entire surface thoroughly by hand.
When the operation is over, rinse the
hob abundantly with tap water. Have
the drain water flow out through the
specific hole and empty the tank (see
"Deactivation").
When these operations have been
performed successfully, dry the
hob carefully using a non-abrasive
cloth. Set the temperature at the
minimum for about 10' to safely dry
the hotplates. If necessary, repeat the
operations described above for a new
cleaning cycle.
For the parts removed, clean with
detergent and tap water, dry carefully
and reposition in the correct order.
Replace the parts removed in the
correct order (if necessary)
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
CHROMED HOTPLATES: Use a
resistant plastic scraper to remove
incrustations. Clean the hotplate with
a moist cloth. Turn the appliance on
to dry it (See Daily activation). When
the operations described are finished,
lubricate it with a light coating of food-
safe Vaseline.
CLEANING FOR PROLONGED
DEACTIVATION / See chapter 5 /
Daily decommissioning / Prolonged
decommissioning.
Air out the appliances and rooms
regularly.
SUMMARISED TABLE /
OPERATION - FREQUENCY
Before proceeding with the ope-
rations, see chap.2 "Duties and
qualifications"
Should a problem occur, the ge-
neric operator performs the first
search and, if qualified, elimina-
tes the cause of the problem and resto-
res the appliance correctly.
If the problem cannot be resol-
ved, turn the appliance off, di-
sconnect it from the electrical mains
and shut all the supply valves. Then
contact authorized customer service.
The authorized maintenance te-
chnician intervenes when the
generic operator was not able to pin-
point the cause of the problem, or
whenever restoration of correct ope-
ration of the appliance entails execu-
ting operations for which the generic
operator is not qualified.
- 18 -
MAINTENANCE
9.
EN