Maintenance - MBM FTG74A Manuel D'installation Et D'utilisation

has no obstructions (Fig.3).
Use a standard sprayer to apply the
liquid detergent on the whole surface
of the hob and, using a non-abrasive
sponge, clean the entire surface tho-
roughly by hand.
The capacity of the container col-
lecting drained material is limited.
Check it frequently so that it does not
spill over (Fig. 4).
OBLIGATIONS - PROHIBITIONS -
ADVICE
Before proceeding see chap-
ters 2 and 5.
If the appliance is connected to a
flue, the exhaust pipe must be
cleaned according to that forese-
en by specific regulatory provisions of
the country (contact your installer for
information).
The appliance is used to prepare
food products. Keep the applian-
ce and the surrounding area con-
stantly clean. Failure to keep the ap-
pliance in ideal hygienic conditions
could cause it to deteriorate quickly and
create dangerous situations.
Filth deposit built up near heat
sources can burn during normal
use of the appliance and create
dangerous situations. The appliance
must be cleaned regularly and every in-
crustation or food deposit removed.
The chemical effect of salt and/or
vinegar or other acid substances
can in the long run cause the insi-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
Fill the recipient 3/4 to handle it
safely. Once the recipient has
reached 3/4 its capacity, remove it
from its seat, empty it and put it back
in place.
Empty the container in com-
pliance with waste disposal pro-
cedures in force in the country where
the appliance is used and reposition
the emptied recipient in its housing.
de of the hob to corrode during cooking.
At the end of the cooking cycle of such
substances, the appliance must be
washed thoroughly with detergent,
abundantly rinsed and carefully dried.
Be careful not to damage stain-
less steel surfaces. No not use
corrosive products, abrasive material
or sharp tools.
The liquid detergent for cleaning
the hob must have certain che-
mical features: pH greater than
12, without chlorides/ammonia, visco-
sity and density similar to water. Use
non-aggressive products for cleaning
the inside and outside of the applian-
ce (use detergents on the market for
cleaning steel, glass and enamel).
Carefully read the indications car-
ried on the labels of the products
used. Wear protective equipment
suitable for the operations to be perfor-
med (see the protective equipment car-
ried on the package label).
In the event of prolonged inacti-
vity, besides disconnecting the
supply lines, you must thorou-
- 17 -

MAINTENANCE

8.
EN
9.