MBM FTG74A Manuel D'installation Et D'utilisation page 40

The layout of the keys in the figures is
purely indicative and can be subject to
variations.
THERMOSTAT KNOB. It perfor-
1
ms three different functions:
1. Igniting the pilot light and burner.
2. Adjusting the temperature / power
3. Turning the appliance off.
PIEZOELECTRIC
2
performs one function: 1. When
pressed, it produces the spark to ignite
pilot light.
STARTING PRODUCTION
Before proceeding with the ope-
rations see: "General safety in-
formation / Residual risks"
When heating, lubricate the
hotplate with vegetable oil to
facilitate cooking.
It is strictly forbidden to use
the appliance as a fryer.
When loading the product into
the appliance and unloading
it, there is a residual risk of being
burnt; this risk can occur coming
into unintentional contact with: hob
- cooking compartment - recipients
or material processed.
SWITCHING ON / see SECT. IMA-
GES - REF. o)
Turn the knob while holding it in
•
the piezoelectric position (Fig.1A).
Simultaneously press the piezoe-
lectric button several times (Fig.1B)
until the pilot light is lit.
Release the knob after about 20"
•
and check to make sure the pilot li-
ght remains lit. The pilot light can be
seen through the hole on the panel.
When the pilot light has been lit, turn
•
the thermostat knob to the desired
temperature / power (Detail 1C).
The cooking
power is regulated following the
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
indications on the knob.
•
LOADING/UNLOADING THE PRO-
BUTTON: It
DUCT / see SECT. IMAGES - REF. o)
food on the hotplate.
When the set temperature has been
reached, place the product to be co-
oked directly on the hotplate (Fig. 2).
When cooking is over, remove the
item from the appliance using the spe-
cific cookware and put it in a place
prepared beforehand.
After the product has been unloaded,
load it once again or else perform the
operations described in "Deactivation".
DEACTIVATION / see SECT. IMA-
GES - REF. p)
te/s to wear quickly.
cleaning has been finished, turn the
appliance on for approximately 10'.
Wait for the temperature of the hotpla-
te to cool off so that the operator is
not burnt.
temperature /
Check to make sure the drain piping
- 16 -
In the dual control (2 thermostat
knobs) each knob operates each
individual hotplate (see layout D).
Turn the knob/s to "Zero" to stop
heat generation.
Do not use pans or other contai-
ners to cook on the hotplate.
Wait for the correct temperature
to be reached before placing
Before proceeding see chapters 5
Humidity residue deposited on
the hotplate/s can damage the
appliance and cause the hotpla-
In order to eliminate all humidity
residue on the hotplates thus
avoiding quick wear, once routine
8.
EN