Front Panel (Lfo, Sample And Hold Section) - ARP ODYSSEY Manuel D'utilisation

Front panel (LFO, SAMPLE AND HOLD section)

a
b
c
d
e f g
- 9 -
a . LFO FREQ (LFO speed) slider (pink) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [0 .2Hz...20Hz]
Adjusts the LFO speed.
Raising the slider makes the speed faster.
b . S/H input level slider (blue)
Adjusts the level at which the waveform output from VCO‐1 is input to the S/H
MIXER.
c . S/H input level slider (white)
Adjusts the level at which noise or the square wave output from VCO‐2 is input
to the S/H MIXER.
d . S/H OUTPUT LAG slider (yellow)
Smooths the changes of the S/H output voltage.
As you move the slider toward the "MAX" position, a greater amount of the
smoothing will be applied.
e . S/H input source switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [VCO-1
Selects the source (VCO‐1 waveform) that is input to the S/H MIXER.
f . S/H input source switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[NOISE GEN, VCO-2
Selects the source (noise or VCO‐2 square wave) that is input to the S/H MIXER.
g . S/H trigger source switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[LFO TRIG, KYBD TRIG]
Selects the signal (either the output of the LFO or the output of the keyboard) that
is used as the trigger when detecting an audio signal sent from the S/H MIXER.
, VCO-1 ]
]