Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
About MIDI
Connecting MIDI devices
By connecting the ARP ODYSSEY to a computer or external MIDI sequencer, you can
control the sound generator of the ARP ODYSSEY from an external device.
Use a commercially available MIDI cable to connect the ARP ODYSSEY's MIDI
IN connector to the MIDI OUT connector of your external MIDI device (see
"Connections" on page 14).
MIDI IN connector: This receives MIDI messages from other MIDI devices. Connect
this connector to the MIDI OUT connector of the other device.
Note messages (velocity is ignored) are the only type of MIDI messages that the
ARP ODYSSEY can receive via its MIDI IN connector. The range of notes that
can be received is 012 (C0) – 127 (G9).
MIDI channel
MIDI has sixteen channels, 1 – 16.
If you connect an external MIDI device, you must set the MIDI channel of the ARP
ODYSSEY to match the MIDI channel of your external MIDI device.
Setting the MIDI channel of the ARP ODYSSEY
Here's how to set the MIDI channel of the ARP ODYSSEY. With the factory settings,
this is set to channel 1.
For details on how to set the MIDI channel of your external device, refer to its
Tip:
operating manual.
ARP ODYSSEY
1.
While holding down the C3 and C4 keys of the keyboard, press the power switch
to turn the power on. The ARP ODYSSEY is in MIDI channel setting mode; the
power LED blinks* to indicate the MIDI channel.
C3
C4
* The LED repeatedly blinks to indicate the MIDI channel setting; once for
channel 1, twice for channel 2, and so on.
2.
MIDI channels (1 – 16) are assigned to the keyboard as follows. Press the key
corresponding to the MIDI channel that you want to assign (e.g., press the D2 key
to assign channel 2). The power LED continues blinking.*
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
3.
Press the C6 key to save the MIDI channel setting. When the setting has been
saved, the power turns off.
ARP ODYSSEY Module
Use the rear panel MODE SWITCH 1 – 4 to specify the MIDI channel. The MIDI
channel settings are shown in the following table. The MIDI channel changes
immediately when you change the setting.
Although you can change the MIDI channel during use, currently‐sounding
notes will turn off. Pitch bend is also reset.
1
2
ON
1
2
3
4
5
6
ON
1
2
3
4
9
10
ON
1
2
3
4
13
14
ON
1
2
3
4
- 17 -
3
4
ON
ON
1
2
3
4
1
2
3
4
7
8
ON
ON
1
2
3
4
1
2
3
4
11
12
ON
ON
1
2
3
4
1
2
3
4
15
16
ON
ON
1
2
3
4
1
2
3
4
C6
ON
1
2
3
4
ON
1
2
3
4
ON
1
2
3
4
ON
1
2
3
4
Publicité
Chapitres
Table des Matières
Dépannage
