Turning The Power On; Turning The Power Off; Auto Power-Off Function - ARP ODYSSEY Manuel D'utilisation

Turning the power on

Turn off the power of your powered monitor speakers or other external output
device before you power‐on the ARP ODYSSEY.
1.
Lower the ARP ODYSSEY ' s VCA level slider (page 11) and VCA GAIN slider
(page 10) to the minimum position.
2.
Press the ARP ODYSSEY ' s power switch to turn the power on. The power LED
will light up.
3.
Lower the volume controls of your powered monitors or external output system,
and then turn their power on.
4.
Raise the volume controls of your powered monitors or external output system to
an appropriate level, and adjust the ARP ODYSSEY
If you are not familiar with how to create sounds, we suggest that you now
Tip:
adjust the settings as described in the "Basic settings" section (page 16).

Turning the power off

1.
Lower the volume of your powered monitors or external output system, and turn
their power off.
2.
Hold down the ARP ODYSSEY ' s power switch, and release it when the power
LED goes dark.

Auto power-off function

The ARP ODYSSEY has an auto power‐off function that automatically turns the
power off when approximately four hours have elapsed since the instrument was
last played or used. With the factory settings, the auto power‐off function is enabled.
Changing the auto power-off setting
If desired, you can enable or disable the auto power‐off function.
Do not turn off the power while you are changing this setting. Doing so may
destroy data, causing a malfunction.
The setting of the auto power‐off function is remembered even after you turn
Tip:
off the power.
s VCA level slider.
'
- 15 -
Disabling the auto power-off function
ARP ODYSSEY
1.
While holding down the C3, D3, and E3 keys of the keyboard, press the power
switch to turn the power on.
C3 D3 E3
2.
When the power LED blinks several times and then remains lit, release the power
switch. Each time you subsequently turn the power on, the power LED will blink,
indicating that the auto power‐off function is disabled.
ARP ODYSSEY Module
Turn the rear panel MODE SWITCH 5 off (downward position).
The auto power‐off function is disabled; you don't have to turn
the power off and on again to apply the setting.
Enabling the auto power-off function
ARP ODYSSEY
1.
While holding down the C3, D3, and F3 keys of the keyboard, press the power
switch to turn the power on.
C3 D3 F3
2.
When the power LED lights up, release the power switch. Each time you
subsequently turn the power on, the power LED will light up immediately,
indicating that the auto power‐off function is enabled.
ARP ODYSSEY Module
Turn the rear panel MODE SWITCH 5 on (upward position).
The auto power‐off function is enabled; you don't have to turn
the power off and on again to apply the setting.
ON
1 2 3 4 5
ON
1 2 3 4 5