Gallignani GA FB 12 Manuel D'utilisation Et D'entretien page 97

The baler is identified by a set of serial numbers and/
or production codes.The position of the different
identification data is shown below.
NOTE: always state the machine identification data
to your Dealer while asking for spare parts or service
interventions.
Identification data plate - - Figures 1÷ ÷ ÷ ÷ 2
Manufacturer's data plate (1), for all countries except
France.
Data plate (2), for France only.
Location: frame right side. It contains the following
data:
-- baler type
-- Road type--approval number, when required
-- Baler frame number
-- Weight
-- CE mark
-- Manufacturing year.
Other data are given in the type--approval certificate.
In some countries (e.g. Russia) the manufacturer's
plate (1 or 2) is placed next to a decal/label with the
type approval.
Identification data - - Figure 3
The baler technical type and the frame number are
punched on the frame right side (2) and on the data
plate (1).
BALER IDENTIFICATION
1
2
2
3
SECTION 1
1
2
1
E
N
G
L
I
S
H
1- -3