Gallignani GA FB 12 Manuel D'utilisation Et D'entretien page 109

Decal 18
Do not approach this area
with hands or other parts of
the body: reciprocally moving
parts
crushing injuries or wounds.
Before approaching, switch
the engine off and wait for all
parts to stop completely.
341000016
The Operator's Manual, the Service Record
D
Booklet, the Pre--Delivery card, the on--board
computer, the electrical cables to couple baler
and tractor, the universal joint removable part
and the kit of the shearbolts are placed in the
round baler front twine--box.
The tractors using the round baler must be "cus-
D
can cause severe
Decal 20
Do not operate the baler if the uni-
versal joint guards are not in-
stalled.
These decals or others, having
a similar meaning, are placed
on the power take- -off telesco-
pic shaft guards.
UNPACKING AND ARRANGEMENT
Decal 19
Keep away from the
pivoting area of the
tractor/baler coupling
devices when the en-
gine is running.
341000080
tomized" and require a coupling to fasten the
ECU inside the cab and a special electrical con-
nection to power the round baler electronic circuit
and motors.
For any information on the above installation,
D
refer to your dealer.
SECTION 1
E
N
G
L
I
S
H
1- -15