Electromagnetic Emissions - Gallignani GA FB 12 Manuel D'utilisation Et D'entretien

GENERAL INFORMATION
All the machine electric components emit an electromagnetic field that varies depending on the component fea-
tures.
As all the situations that might occur in different practical conditions are hard to be defined, a maximum limit of
electromagnetic emissions has been set.
This is to prevent interferences and/or damages to the machine control and/or check systems.
E
ATTENTION:
N
G
1 - - any additional equipment installed on the machine and not produced by "Gallignani" must bear the CE mark.
L
2 - - The max. power (W) of the auxiliary equipment cannot exceed the limits set by the national authorities.
I
3 - - The electromagnetic field radiated by the machine electronic components cannot exceed the max. limit of
S
24 V/m.
H
Many countries have special regulations for road transport, concerning, in particular:
-- maximum permitted width, length and weight without asking for an authorization to the road owning com-
pany;
-- max. length of the vehicle formed by tractor and baler;
-- maximum allowed width and length, with permits from the road owning company, without an escort car or
cars;
-- maximum allowed speed;
-- use of lights, plates or flags to indicate a slow--moving vehicle;
-- additional signs for maximum dimensions.
Thus, the baler owner and/or operator should get information about local regulations and prescriptions
in force.
The machine may be fitted with special guards or other safety devices, in compliance with the general or local law
regulations in force.
Some of these regulations require an active participation by the operator, to ensure and keep the safety devices
operating and the compliance with the manufacturer's prescriptions.
Locally, supplementary regulations can be enforced and the operator should comply with them.
1- -16

ELECTROMAGNETIC EMISSIONS

NOTICE FOR ROAD TRANSFER
LAW PRESCRIPTIONS