Commissioning; Function Check; Switching On The Measuring Device - Endress+Hauser ASP Station 2000 Mode D'emploi

6 Commissioning

90
6 Commissioning
6.1

Function check

If you can answer the following questions with YES, then you can commission the device (see Sec-
tion 6.2 "Switching on the measuring device"). If the answer is NO, then please refer to the appro-
priate sections:
General
Is the power supply connected?
Is the sampling hose correctly laid to the sampling point?
Is the sampling hose correctly connected to the unit?
When connecting a digital input signal, digital output signal and/or ana-
logue input signal
Is the signalling connector correctly wired and connected to the terminal board?
6.2

Switching on the measuring device

When you connect the power supply, the display lights up and signals "UNIT OFF". When you press
the operating key beneath the "ON" field, the message "UNIT ON" appears. The device is operati-
onal.
ASP Station 2000
Section reference
Chapter 4.1.5
Chapter 3.3.4
Chapter 3.4
Section reference
Chapter 4.1
Endress+Hauser