Connecting An Rs485 Interface (Optional); Connecting Profibus-Dp (Optional); Degree Of Protection; Post-Connection Check - Endress+Hauser ASP Station 2000 Mode D'emploi

ASP Station 2000
Endress+Hauser
4.1.8

Connecting an RS485 interface (optional)

(Wiring diagram Page 79: terminal board)
The RS485 interface is located on the terminal board.
4.1.9

Connecting PROFIBUS-DP (optional)

With Profibus coupler on top-hat rail in electronics compartment, connection via RS232; baudrate
9600 kBaud.
Fig. 14: Profibus coupler
For additional information on the connection and wiring of the Profibus-DP module, see the addi-
tional description in the Operating Instructions of the ASP Station 2000 Profibus coupler (see
10.10 "Documentation").
4.2

Degree of protection

The individual components meet the requirements of the following protection types:
Controller:
Sample compartment with closed doors:
Electronics compartment:
4.3

Post-connection check

After completing the device's electrical connections, carry out the following checks:
Device status and specifications
Is the device or cable damaged (visual inspection)?
Electrical connection
Does the supply voltage match the information on the nameplate?
Do the cables used meet the relevant specifications?
Are the mounted cables relieved of tension?
IP 65
IP 54
IP 43
Notes

Notes
Compare nameplate on the
device
Chapter 4.1

4 Wiring
81