Creating Programmes - Endress+Hauser ASP Station 2000 Mode D'emploi

ASP Station 2000
Endress+Hauser
Power down The output contact is switched on a power failure.
Sample
The output contact is switched on a sample.
Bottle
The output contact is switched on bottle replacement.
Ext. stop
The output contact is switched on an external stop.
Fill. end
The output contact is switched on exiting the sampling programme.
No flow
The output contact is switched if the device was unable to draw in any sampling
medium (e.g. blocked suction hose).
CS 1/2:
The output contact is switched on the error message "CS 1/2".
Error
The output contact is switched on any error message.
Suction
Active during suction when sampling.
Suck.+Dos.:
The output contact is switched when the device sucks in and doses a sampling medium.
Overfill
The output contact is switched when a bottle is overfull.
6.4.4

Creating programmes

Menu structure:
01:15 04°C 21.05.02
unit off
on
â á
Esc
man aut off ..->
<-.. set rep stat
setup
Quick-Setup
Info
Basic Settings
Program Selection
Creating Programmes
Service
â á
Esc
Fig. 34: Creating programmes menu structure
<-'
Program Selection
number :
prog-nr : Program 1
<-'
â á
Esc
â á
Esc
Program Selection
number :
prog-nr : Program 1
â á
Esc
6 Commissioning
1
1 2
1+event
2+event
<-'
<-'
1 Program 1
Program 2
Program 3
Program 4
<-'
95