Lenze Global Drive 8200 vector Instructions De Montage page 82

Show/Hide Bookmarks
Commissioning - 8200 vector without function module
•
The 8200 vector can only be used when the FIF cover is mounted!
– If the FIF cover is not mounted, the 8200 vector is inhibited (keypad:
•
Since the 8200 vector without function module does not have any control terminals, starting and stopping during operation is also
possible via switching the mains.
– For cyclic switching: Observe break times of 3 minutes!
•
Function
restarts automatically as soon as the mains connection is built up again.
•
If the drive does not start at step
Step
 Plug in the keypad
‚ Switch on the mains voltage.
Self start possible!
ƒ Select the setpoint via the function p
j j
.
Any faults or errors during commissioning or operation?
j
stores the setpoint at the time when operation is interrupted by switching the mains or mains failures. The drive
ƒ
c
( is not off), press
Note
The keypad is not included in the delivery package.
The controller is ready for operation after approx. 1 second.
dc
Keypad:
j
activate
CW rotation:
CCW rotation
1
! It is under the dummy cap
dc
).
U
to enable the 8200 vector.
g w j
z c
is off. The drive should be running now.
Display indicates output frequency.
y
0
(Delivery status).
8200vec271
see chapter
8 8
"Commissioning" Commissioning
g
9
" Fault recognition and
elimination"