Lenze Global Drive 8200 vector Instructions De Montage page 134

Show/Hide Bookmarks
Commissioning
Code table
Code
No. Name
*
C0135 Controller control
word (parameter
channel)
C0138* Process controller
setpoint 1
(PCTRL1-SET1)
C0140* Additive frequency
setpoint
(NSET1-NADD)
C0141* Setpoint normalised
56
Possible settings
Lenze Selection
Bit Assignment
1|0 JOG1, JOG2, JOG3 or C0046 (NSET1-JOG1/3,
NSET1-JOG2/3)
00 C0046 active
01 JOG1 (C0037) active
10 JOG2 (C0038) active
11 JOG3 (C0039) active
2 Current direction of rotation (DCTRL1-CW/CCW)
0 not inverted
1 inverted
3 Quick stop (DCTRL1-QSP)
0 not active
1 active
4 Stop ramp function generator (NSET1-RFG1-STOP)
0 not active
1 active
5 Ramp function generator input = 0 (NSET1-RFG1-0)
0 not active
1 active (deceleration to C0013)
6 UP function motor potentiometer (MPOT1-UP)
0 not active
1 active
7 DOWN function motor potentiometer (MPOT1-DOWN)
0 not active
1 active
8 Reserved
9 Controller inhibit (DCTRL1-CINH)
0 Controller enabled
1 Controller inhibited
10 TRIP set (DCTRL1-TRIP-SET)
11 TRIP reset (DCTRL1-TRIP-RESET)
0 Þ 1 Edge causes TRIP reset
13|12 Parameter set changeover (DCTRL1-PAR2/4,
DCTRL1-PAR3/4)
00 PAR1
01 PAR2
10 PAR3
11 PAR4
14 DC injection brake (MTCRL1-DCB)
0 not active
1 active
15 Reserved
0.00 -650.00
0.00 -650.00
0.00 -100.00
EDK82EV903 DE/EN/FR 1.0
{0.02 Hz} 650.00 The value set will be lost when switching
{0.02 Hz} 650.00
100.00 The value set will be lost when switching
{0.01 %}
IMPORTANT
•
Control via parameter channel. The most
important control commands are grouped as
bit commands.
•
C0135 cannot be changed using the keypad
RFG1 = Ramp function generator main setpoint
Sets "external error" ( E E E E E E E E r r r r , LECOM No. 91)
(^LEERER MERKER)
the mains!
•
Selection if C0412/4 = FIXED-FREE
•
Display, if C0412/4 ≠ FIXED-FREE
j
•
Selection via function of the keypad or
the parameter channel
•
Is added to main setpoint
•
Value is stored when switching the mains or
removing the keypad
the mains!
Only effective if C0127 = 1
Reference: C0011
L