Lenze Global Drive 8200 vector Instructions De Montage page 135

Show/Hide Bookmarks
Code
No. Name
C0142 Start condition
v v
C0143* Selection of
v
flying-restart fl i
C0144 No temperature
v v
depending chopper p
frequency derating f
C0145* Process controller
v
setpoint source i
C0148* Motor parameter
s
identification
L
Possible settings
Lenze Selection
1
0 Automatic start inhibited
Flying restart not active
1 Automatic start, if X3/28 = HIGH
Flying restart not active
2 Automatic start inhibited
Flying-restart circuit active
3 Automatic start, if X3/28 = HIGH
Flying-restart circuit active
0
0 Max. output frequency (C0011) ... 0 Hz
1 Last output frequency ... 0 Hz
2 Frequency setpoint addition (NSET1-NOUT)
3 Act. process controller value (C0412/5) addition
(PCTRL1-ACT)
1 0 No temperature-depending chopper frequency
g pp derating
d ti
Automatic chopper frequency derating at ϑ
1
0
0 Total setpoint (PCTRL1-SET3)
1 C0181 (PCTRL1-SET2)
2 C0412/4 (PCTRL1-SET1)
0 0 Ready
1 Start identification
•
•
V/f-rated frequency (C0015), slip compensation
(C0021) and motor stator inductivity (C0092) are
calculated and saved.
The motor stator resistance (C0084) = total
resistance of motor cable and motor is measured
and saved
EDK82EV903 DE/EN/FR 1.0
Commissioning
Code table
IMPORTANT
Start after LOW-HIGH level change at X3/28
Start after LOW-HIGH level change at X3/28
Motor speed selected for the indicated range p
The corresponding value is input after controller p g
enable. bl
- 5 °C
max
Main setpoint + additional setpoint
•
Setpoint selection not possible via
– JOG values
j
– function of the keypad
– C0044, C0046 and C0049
– in connection with manual/remote in connection with manual/remote
changeover, skip frequencies, ramp
function generator, additional setpoint
•
Activate the automatic DC-injection brake
(auto DCB) with C0019 = 0 or C0106 = 0
Only when the motor is cold!
1. Inhibit controller, wait until drive is in
standstill
2 Enter the correct motor data under C0087 2. Enter the correct motor data under C0087,
C0088, C0089, C0090, C0091 (see motor
nameplate).
v
3. C0148 = set 1 by
4. Enable controller
The identification
c
– starts, Off
– takes approx. 30 s
– is completed when
5. Controller inhibit
g
p
c
is on again
57