Lenze Global Drive 8200 vector Instructions De Montage page 136

Show/Hide Bookmarks
Commissioning
Code table
Code
No. Name
*
C0150 Controller status
word 1 (parameter d 1 (
channel) channel)
*
C0151 Controller status
word 2 (parameter (p
channel) h l)
C0152 Service code
(A)
*
C0155 Extended status word
C0156* Current threshold
58
Possible settings
Lenze Selection
Bit Assignment
0 Mapping of C0417/1
1 Pulse inhibit (DCTRL1-IMP)
0 Power outputs enabled
1 Power outputs inhibited
2 Mapping of C0417/3
3 Mapping of C0417/4
4 Mapping of C0417/5
5 Mapping of C0417/6
6 Output frequency = 0 (DCTRL1-NOUT=0)
0 false
1 true
7 Controller inhibit (DCTRL1-CINH)
0 Controller enabled
1 Controller inhibited
11|10|9|8 Controller status
0000 Controller initialization
0001 Mains voltage off (at external supply of the control
section ofthe drive controller)
0010 Switch-on inhibit
0011 Operation inhibited
0100 Flying-restart circuit active
0101 DC-injection brake active
0110 Operation enabled
0111 Message active
1000 Active error
12 Overheat warning (DCTRL1-OH-WARN)
0 No warning
ϑ - 5 °C reached
1
max
13 DC-bus overvoltage (DCTRL1-OV)
0 No overvoltage
1 Overvoltage
14 Mapping of C0417/15
15 Mapping of C0417/16
Bit Assignment
0 ... 15 Mapping of C0418/1 ... C0418/16
Bit Assignment
0 not ready for operation (NOT DCTRL-RDY)
1 not assigned
2 I (MCTRL1-IMAX)
max
3 Pulse inhibit (DCTRL1-IMP)
4 not assigned
5 Controller inhibit (DCTRL1-CINH)
6 TRIP (DCTRL1-TRIP)
7 not assigned
8 Collective message
(DCTRL1-OH-PTC-LP1-FAN1 warning)
9 PAR B0 (DCTRL1-PAR-B0)
10 PAR B1 (DCTRL1-PAR-B1)
11 ... 15 Reserved
0 0
EDK82EV903 DE/EN/FR 1.0
{1 %} 150 Programmable current threshold
IMPORTANT
•
Scan of the controller status via parameter p
channel. The most important status h l Th i
information are grouped as bit pattern information are grouped as bit pattern.
•
Some bits can be freely assigned to internal
digital signals
• •
Configuration in C0417 Configuration in C0417
• •
In keypad: display only (hexadecimal) In keypad: display only (hexadecimal)
•
The bits can be freely assigned to internal
digital signals g g
•
Configuration in C0418
•
In keypad: display only (hexadecimal)
Modifications only by Lenze Service!
Signal output configuration under C0008 or
C0415
L