Description Of The Device; Application; Improper Use; Accessories - Kramp MPP Manuel D'utilisation

Article XII, Liability
1. Except with respect to conformity with our guarantee obligation in accordance with the stipulations of the previous article
and subject to stipulations of imperative law, any liability on our side (including liability pursuant to wrongful act) is
excluded, apart from intention or gross fault on our side and subject to the liability explicitly accepted by us. In all cases,
irrespective of whether direct damage, bodily injury or delay damage or damage with whatever designation is involved, our
damage shall not exceed the compensation of the amount the other party is due to us pursuant to the agreement with the
other party concerned.
2. We shall not accept any liability for intention and/or gross fault of non-executive subordinates.
UK
3. We shall never accept any liability with respect to verbally provided advice, information, recommendations, etc.
4. All our subordinates can on equal terms with us appeal to the stipulations of this article towards the client and, if
necessary, towards third parties.
5. The other party shall be responsible for providing the legally prescribed safety devices and for the consequences of any
absent safeties, as well as for complying with all applicable legal regulations with respect to the products.
Note:
A copy of our complete General Delivery and Assembly Conditions will be provided upon request and free of charge.
Damage or costs related to the product as a result of non-compliance with the regulations stated in this manual (including
but not limited to: safety measures and operating instructions) are not covered by the warranty.
In case components are replaced by spare parts which were not supplied by Kramp Groep B.V., or which did not obtain our
explicit consent, then any liability of Kramp Groep B.V. for the supplied product expires. With the manual supplied with the
product, no claim in any form can be made under warranty in case of malfunctioning of the hydraulic system or any
(consequential) damage whatsoever.
For optimal use with a minimum number of operational stops, it is important that the hydraulic system is designed and
produced according to the requirements of the installation and/or end user, and that it is used according to its design and that
periodical maintenance is performed by competent personnel.
4
2.0

Description of the device

2.1

Application

The hydraulic power pack shall be used for generating hydraulic energy (pressure and flow). This hydraulic
energy is transported to one or more actuators (motors, cylinders, etc.) by means of hoses and/or pipes
to be connected to the power pack. The actuators can be operated by one or more control valves. The
installed power may vary dependent on the delivered hydraulic power pack.
2.2

Improper use

• Non-observance of the instructions, warnings and/or safety measures as mentioned in this user
manual may result in injury!
• The power pack should be used according to its intended use.
• Modifications of the hydraulic power packs or application of the hydraulic power packs for purposes
other than mentioned above is strictly forbidden. This prohibition applies to all modifications of or with
respect to components other than originally delivered by Kramp Groep B.V..
• Do not overload the power pack in any way, provide overload protection.
• Do not operate the power pack when parts have been damaged or are missing.
• Immediately stop the power pack in case of broken hoses or pipes.
• Immediately stop the power pack in case of defective cylinders.
• Do not carry out any repair or maintenance activities on a running power pack. Shut off the power or
fuel supply.
• Do not insert any objects in rotating parts such as fans of coolers and/or electromotors.
2.3

Accessories

Drip trays and/or transport wheels are NOT a part of the default scope of delivery.
2.4

Safety function

In order to prevent the hydraulic power pack from exceeding the maximum pressure, the hydraulic power
pack has been provided with a hydraulic safety device. This has been set to the required operation pressure
in the factory and may NEVER be adjusted. The safety device has been sealed for this. If the seal is broken,
the guarantee concerning the power pack will become null and void.
. .
www kramp com