Télécharger Imprimer la page

Adjusting The Start-In-Gear Protection Device - Yamaha 25BMH Manuel D'entretien

Publicité

CHK
CONTROL SYSTEM
ADJ
2
1
c
b
a
ADJUSTING THE START-IN-GEAR
PROTECTION DEVICE
• Make sure that the engine is not run-
• Remove the plug caps.
1. Check:
Checking steps
(1) Set the shift lever
(2) Check that the starter rope
(3) If the starter rope can be pulled out,
2. Adjust:
Adjustment steps
(1) Set the shift lever
(2) Turn in or out the adjusting nut
NOTE:
• Check again that the starter rope can
• Check again that the starter rope can be
b
3-18
CAUTION:
ning.
Start-in-gear protection device
reverse position.
pulled out.
perform the adjustment.
the starter stop wire so that the starter
a
stopper end
is aligned with the hole
on the starter case
not be pulled out when the shift is
engaged.
pulled out when the shift is in neutral.
E
1
in forward or
2
cannot be
1
in neutral position.
c
on
b
.

Publicité

Chapitres

loading

Ce manuel est également adapté pour:

30hmh