Publicité
CHK
CONTROL SYSTEM
ADJ
(4) Check that the throttle control lever
is in contact with the stopper
bottom cowling.
(5) If they are not in contact, adjust the
length of the joint link
throttle control lever seats on the stop-
per on the bottom cowling.
NOTE:
After adjustment, open and close the throt-
tle repeatedly for several times to reassure
the correct positioning.
(6) Check that the magnet base stopper
is in contact with the stopper on the
engine body (full-open end stopper)
NOTE:
If they are not in contact, perform the
adjustment with full-open throttle.
Refer to "Adjustment with full-open throt-
tle:" on page 3-6.
(7) Check that full-open stopper
carburetor control link is in contact with
the stopper on the carburetor body
NOTE:
If they are not in contact, adjust the carbu-
retor control link.
Refer to "Adjusting the carburetor control
link:" on page 3-7.
3-14
E
5
6
on the
c
so that the
3
4
.
d
of the
e
.
Publicité
Chapitres
