Nice Riva Serie Instructions Et Avertissements Pour L'installation page 68

5 8 BASIC SETTINGS
5 8 1 Selection of gate manoeuvring speed
The speed of the gate leaf opening and closing can be 'slow' or 'fast'
(the type selected is indicated by the LED 'L2' being on or off ("Figure
40"):
– LED 'L2' off = 'slow' operating speed has been selected
– LED 'L2' on = 'fast' operating speed has been selected.
1
Press and release the 'P2' button several times until the LED
'L2' remains on or off ("Figure 40").
40
Flash OGI BUS
M M M M
5 8 2 Selection of the operating cycle of the gate
manoeuvre
The 'opening-closing' cycle of the gate leaves can be of the 'single
cycle (semi-automatic)' or 'complete cycle (automatic)' type (the type
selected is indicated by the 'L3' LED on the control unit being on or off
("Figure 41"):
– LED 'L3' off = 'single cycle (semi-automatic)' operation has been
selected (with a first command, the gate opens and remains open
until the next command, which will cause it to close)
– LED 'L3' on = 'full cycle (automatic)' mode has been selected (with
a single command, the gate opens and closes automatically after a
programmed 'pause time'. To adjust the cycle, see paragraph Ad-
justment and verification of parameters.
26 – ENGLISH
Stop Sbs Open
P2
1 Press and release the 'P3' button several times until the 'L3'
LED remains on or off ("Figure 41").
41
Flash OGI BUS Stop
M M M M
single cycle full cycle
Sbs Open
P3