Nice Riva Serie Instructions Et Avertissements Pour L'installation page 63

KEY TO THE SYMBOLS USED IN THE MANUAL
Description
LED 'L1' steady
LED 'L1' flashing slowly
LED 'L1' flashing rapidly
LED 'L1' flashing slowly
LED 'L1' off
Disconnect power supply / Restore power
supply
(remove fuse F2 and the battery pack – if
present)
Wait
Perform the operation within 5 seconds
Press and hold the radio button on the
control unit
Press and release the radio button on the
control unit
Release the radio button on the control
unit
Press and release the desired transmitter
button
Hold down the desired transmitter button
Release the desired transmitter button
Observe when LED 'L1' emits signals
5 2
Table 6
When power is supplied to the control unit it is advisable to carry out
some simple checks:
Symbol
1
31
OFF ON
2
>5 sec <
32
3
5 3
After the initial checks, the control panel must recognise the devices
--- ---
connected to terminals ECSbus and Stop:
1
33
INITIAL CHECKS
on the control unit ("Figure 31") check that the 'ECSbus' LED
flashes regularly (approximately once per second)
Flash OGI BUS
M M M M
Flash OGI ECSbus Stop
M M M M
on the Tx and Rx photocells ("Figure 32") check that the LED
'SAFE' flashes: the type of flashing is not important as it de-
pends on other factors; however, it is important that the LED is
not always off or always on
TX RX
led
SAFE
if all these checks are not correct, disconnect the power sup-
ply to the control unit and check the cable connections already
made. Further useful information can be found in chapters FUR-
THER INFORMATION e TROUBLESHOOTING GUIDE.
STORING CONNECTED DEVICES
on the control unit ("Figure 33") press and hold the 'P2' button
for at least 3 seconds and then release it
Stop Sbs Open
Sbs Open
P2
ENGLISH – 21