Nice Riva Serie Instructions Et Avertissements Pour L'installation page 67

5 7 DELETING A RADIO COMMAND
5 7 1 Deleting a single command associated with a button from the receiver's memory
During the procedure indicated in 'Table 11', you can delete a command associated with a button
DELETING A SINGLE BUTTON FROM THE RECEIVER'S MEMORY
Description
Press and hold the 'Radio' button on the control panel until the procedure is complete
On the transmitter to be deleted
When 'L1' lights up, press and hold the (*4) key you wish to delete and release it after the
'L1' LED on the control panel has flashed 5 times (deletion successful).
(*4) - If the transmitter is memorised in "Mode 1" (see "Memorisation in "Mode 1""), any button can be pressed. If the transmitter is memorised
in "Mode 2" (see "Memorisation in "Mode 2""), the entire procedure must be repeated for each memorised button that must be deleted.
5 7 2 Deleting the receiver's memory (fully)
In a Unidirectional system, the code deletion procedures involve the receiver alone. In a Bidirectional system, it will instead be necessary to delete
the pairing also on the radio remote control.
To perform this procedure, consult the instruction manual of the relevant transmitter.
FULL DELETION OF THE RECEIVER'S MEMORY
Description
Press and hold the 'Radio' button on the control panel and wait
for the 'L1' LED to turn on and off After a few seconds, it will start
flashing.
Deletion modes
To delete the memory of the receiver, release the 'Radio' button
exactly at the 3rd flash.
Check that the 'L1' LED flashes very quickly.
Wait for the 'L1' LED on the control unit to flash 5 slowly. (Deletion
successful)
Symbols used
Symbols used
Table 11
Table 12
---
ENGLISH – 25