Blackmagic Design Desktop Video Manuel D'installation Et D'utilisation page 43

Use the 'edit to tape' feature to export your edit to an external deck
TIP When exporting to tape using the assemble mode, it's always good to add at
least 30 seconds of black to the end of your sequence. This assists with tape post roll
functions and prevents unwanted media appearing directly after your footage.
To export to tape via RS-422 deck control:
1 Make sure the Adobe Premiere Pro preferences are configured correctly as described in
'setting up a Blackmagic Design project' earlier in this section.
2 Open Premiere Pro's 'edit to tape' window by clicking File > export > tape (serial device).
Click on 'recorder settings', select Blackmagic capture from the dropdown menu and click
'settings'. Choose your video standard and format along with audio settings. Click 'ok'. If the
capture format does not match the output format, it can cause confusion for the deck during
preroll and audio might not be exported.
3 Now choose your 'export type' by selecting 'assemble' or 'insert' from the dropdown menu,
enter the desired in point timecode and click 'record'.
When editing to tape, the software waits at the first frame of your project for the deck to drop
into record at the predetermined timecode. Should you find that either the first frame of your
program is repeated or lost during the edit to tape procedure, you will need to adjust the
'playback > video device > offset' setting to bring the deck and computer in sync. You should
only need to do this once with any combination of deck and computer and the correct setting
will be retained.
Using your Favorite 3rd Party Software 43