Machine Programming; Programming Commands; Programming Menu And Service Menu - LAVAZZA BLUE LB2300 Mode D'emploi

Installation of the machine - Service Provider Manual
11

MACHINE PROGRAMMING

All the operations described in chapter
11 must be performed exclusively by the
service provider or specialised techni-
cian, who shall organise all operating sequences
and employ suitable means to ensure strict com-
pliance with safety regulations in force.
The specialist technician or the service provider can
change some of the machine operating parameters
to suit the needs of the users.
Two menus may be used:
1 The programming menu;
2 The service menu;
11.1 Programming menu and Service
menu
To access the programming menu and the service
menu, proceed as follows:
1 Turn off the machine using the power button,
2 Turn on the machine using the power button; whi-
le the hourglass shows up, press and hold the
steam button until the menu appears.
Sections 11.3 and 11.4 list all the functions availa-
ble in this menu.
These menus should be PASSWORD-
protected.
The PASSWORD chosen (default 0000)
should be changed during the 1
prevent unauthorised access. It can be changed
using either the service menu or the programming
menu.
Using the appropriate commands, select:
1 . Access to the programming menu
Programming (the password is requested).
Menu
2. Access to the service menu
Service menu (the password is requested).
3. Exit Exits the machine programming
menu.
• 36 •
All manuals and user guides at all-guides.com
11.2

Programming commands

When the programming and service menus are acces-
sed, the buttons on the keypad take on new functions.
"page up/change" button
This button allows you to:
1 browse the pages within a menu;
2 change the parameters when they are made edita-
ble using the "ENTER" button.
"page down/change" button
This button allows you to:
1 browse the pages within a menu;
2 change the parameters when they are made editable
using the "ENTER" button.
(ENTER) button
This button allows you to:
1 select the function to display;
2 make a parameter/value editable;
3 confi rm the parameter/value when it is made edita-
ble.
use to
st
"C" button
This button allows you to exit without changing the pa-
rameter edited or selected.