Setting The Water Hardness - LAVAZZA BLUE LB2300 Mode D'emploi

Masquer les pouces Voir aussi pour BLUE LB2300:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 58
1. Remove the protective cap of the water inlet.
2. Connect the supply pipe to the machine, screwing
it onto the water inlet located at the rear of the ap-
pliance in the upper right-hand corner (see illustra-
tion).
3. Screw the supply pipe to a cold water tap with a 3/4
gas threaded spout (see illustration).
4. Ensure that the pipe is free of kinks and twists.
The water pressure of the tap should be wi-
thin the limits shown in the Technical spe-
cifi cations table. If the length of the supply pipe
is insuffi cient, contact a specialised retailer or an
authorised technician.
Never use used or old supply pipes; use only those
supplied with the machine.
10.8

Setting the water hardness

This function allows the hardness of the water used to
be set, enabling the machine to indicate the appropriate
timings for the descaling cycle.
Warning. To set the water hardness, careful-
ly read the contents of Chapter 11.
The hardness of tap water varies from region to re-
gion.
For this reason, the appliance can be set according to
the hardness of the water in the region where it is to be
used, expressed on a scale of 0 to 4.
By default, the appliance is set to a standard value
(hardness 3).
All manuals and user guides at all-guides.com
Installation of the machine - Service Provider Manual
The water hardness setting should be adjusted accor-
ding to the limescale content and hardness of the water,
measured using the strip supplied with the machine.
Briefl y immerse the strip (for 1 second) in the water,
and shake gently. After one minute the test results can
be read on the strip.
HARDNESS 4
Sehr weiches Wasser
HARDNESS 3
Weiches Wasser
Mittleres Wasser
HARDNESS 2
Hartes Wasser
HARDNESS 1
HARDNESS 4 (hard)
HARDNESS 3 (medium)
HARDNESS 2 (soft)
HARDNESS 1 (very soft)
HARDNESS 0 (descaling checks disabled)
After performing the test, enter the appropriate value
into the machine.
10.9
Descaling fi lter (BRITA)
To brew a perfect coffee, water is an essential ingre-
dient, no less important than the correct roast level of
the coffee. It should always be clear and fresh.
Thanks to its revolutionary technology, the descaling fi l-
ter purifi es tap water, eliminating all harmful substances
without removing important minerals.
The descaling fi lter should be replaced whe-
never indicated by the machine.
Before descaling, the descaling fi lter should
be removed from the water tank.
For correct installation of the descaling fi lter, please
follow the indications on the packaging of the fi lter.
The fi lter should then be washed.
Access the service menu as described in section 11.1
and view the fi lter washing menu.
2.6
Filter cleaning
Using the appropriate controls, select "Yes" to wash
the fi lter.
2.6
Filter cleaning
Note: the wash cycle cannot and should not
be interrupted.
The display shows:
Filter cleaning
Empty
cof.groun.drawer
Empty the coffee grounds drawer of any liquids. When
removing the drawer, the display shows:
Filter cleaning
in progress
Insert
cof.groun.drawer
WARNING: reinsert the coffee grounds dra-
wer only after emptying it of any liquids.
When the coffee grounds drawer is inserted, the machi-
ne will start dispensing water into the drawer in order to
wash the fi lter. The display shows:
Filter cleaning
in progress
Wait please...
The machine dispenses a preset amount of water
for appropriate washing of the new descaling filter.
When the machine has finished washing the filter,
the display shows:
Filter cleaning
Empty
cof.groun.drawer
Empty the coffee grounds drawer of any liquids. When
removing the drawer, the display shows:
Filter cleaning
in progress
Insert
cof.groun.drawer
When the coffee grounds drawer is inserted, the ma-
chine will starts up automatically. When warm-up and
rinse cycle are complete, the display shows:
Ready
Insert capsule
The machine is now ready to be used.
Note: the machine should be set to the wa-
ter hardness level immediately below the
result of the test; if three squares change colour,
set the machine to water hardness 2.
Yes
^
Lavazza
• 35 •

Publicité

Table des Matières
loading

Table des Matières