Solutions To The Most Common Problems; Technical Features - LAVAZZA LB 951 Mode D'emploi

EN
SETTING THE PRE-DOSED SUPPLY BUTTON DOSES
Press down the supply button to be modified for at least 3 seconds: the machine will notify a signal, i.e. the
1
LED will blink (1 second ON, then 1 second OFF).
Release the button (the coffee supply will start).
2
Once the desired amount of coffee has been obtained, stop supply by pressing the same button.
3
• The minimum dose that can be set is 20 cc (0,6 oz).
• If the programming does not end within 110 seconds, the supply will be stopped automatically. The
machine will notify a signal, i.e. the LED will blink (1 second ON, then 1 second OFF) and the last dose
previously set will be stored into the memory.
• To resume the factory-set values for the set doses, simultaneously press down the two pre-dosed supply
buttons for 5 seconds.

SOLUTIONS TO THE MOST COMMON PROBLEMS

Problem
The machine does not turn on.
The machine produces water rather
than coffee.
The machine takes a long time to
heat up.
The pump is very noisy.
The machine will not supply the
product and the button will blink.
The capsule loader lever will not
close.
The coffee gushes out too quickly
and the espresso cream does not
form.
The three coffee supply buttons will
blink simultaneously.
• Voltage:
• Total wattage:
• Power absorption (stand-by mode):  0,5 W
• Tank capacity:
• Dimensions:
Possible causes
»
T he machine is not connected to
the electric power supply.
»
T he capsule loader lever is up.
»
T he machine has a lot of calcium
deposits.
»
T here is no water in the tank.
»
T here is no water in the tank.
»
U sed capsule drawer is full.
»
C apsule not inserted properly.
»
T he capsule has already been
used.
»
Water heating system damaged.

TECHNICAL FEATURES

220-240V 50/60 Hz
1200 W
1,7 l
H 280 mm L 200 mm P 320 mm
H 11 in L 7,8 in P 12,5 in
Solution
»
Check to see that it is plugged in.
»
P ut the capsule loader lever in the
down position.
»
D ecalcify the machine.
»
F ill up with fresh drinking water.
»
F ill up with fresh drinking water.
»
E mpty the used capsule drawer.
»
R aise the capsule loader lever and
insert the capsule correctly.
»
I nsert a new capsule.
»
Bring the machine to an author-
ized service centre.
• Weight:
• Collector drawer:
• Material used in the body
(accessible parts generally):
4,6 kg / 10,1lb
10 capsules
ABS + PC