Maintenance And Cleaning - LAVAZZA LB 951 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Always ensure that the electricity is disconnected
and wait for the machine to cool.
Do not leave water in the tank and water circuit
for more than 3 days. If this is the case, drain the
tank and circuit, rinse it and refill it with fresh wa-
ter, then carry out a delivery without capsule before
making any coffee or other beverage. Empty and
clean the used capsule drawer every two or three
days or after 10 coffees have been made. Never use
alkaline detergents, solvents, alcohol or aggres-
sive substances and do not dry machine parts in
the oven. Wash the parts (excluding the electrical
parts) in cold or lukewarm water using non-abra-
sive sponges or cloths.
CLEANING THE COFFEE SPOUT
Once a week follow the procedure for
ING COFFEE
without inserting a capsule.
CLEANING THE DROP COLLECTING TRAY
AND USED CAPSULE DRAWER.
Take out the drop collecting tray/used capsule
1
drawer using the handle.
Remove and empty the inner used capsule
2
drawer.

MAINTENANCE AND CLEANING

DISPENS-
Check periodically to see if the capsule drawer is
full in order to prevent malfunction and damage
to the machine.
The upper and lower drop collecting trays can
3
be cleaned by lifting their grills. Wash and dry all
parts before replacing.
DECALCIFICATION
The formation of calcium or lime is a normal
consequence of using the machine; decalcifica-
tion/descaling should be done after every 3 or
4 months of usage and/or when a reduced flow
of water is noticed.
Decalcification can be done using a decalcifica-
tion product for coffee-makers of the non-toxic
harmless type commonly found on the market.
Do not under any circumstances use vinegar as a
decalcification solution.
Empty the tank and fill it with a decalcification
1
product dissolved in water as specified on the
decalcification package, turn on the machine
and place a container under the spout.
Press the coffee dispenser button and fill a cup-
2
ful.
Turn off the machine, let it sit for 10 -15 minutes
3
and repeat operations [2] and [3] until the tank
is empty.
Wash and fill the tank with fresh drinking water,
4
reposition it and place a container under the
spout.
Wait until the machine heats up, press the cof-
5
fee dispenser button and let it run until the tank
is empty.
EN

Publicité

Table des Matières
loading

Table des Matières