Electrolux 6 GN 1/1 Installation, Utilisation Et Entretien page 28

USA
4.3.7 CORE PROBE USE
(PRODUCT CORE TEMPERATURE CONTROL)
The core probe allows accurate control of the core temperature
of the product being cooked. This enables setting of the required
value (from 50°C to210°F) (10°C to 99°C) and automatic stopping
of cooking when that value is reached.
Attention: The core probe is a precision component. Absolutely
avoid impacts, forcing when inserting, and pulling of the fl exible
cable (in particular when using the trolley-mounted structures).
The warranty does not cover the replacement of core probes
damaged by improper use.
After selecting the time icon select that of the core probe and
press START to start the cycle.
- Wait until the compartment temperature fi eld indicates reaching
of preheating (the message LOAD appears).
- Open the door and introduce the product to be cooked.
Attention! Risk of burns.
Always open the door with caution when the oven is hot.
1) Remove the core probe "A" from its seat "B" and insert it in
the product without forcing excessively, making sure the tip (the
sensitive part) is positioned near the centre of the product.
MULTIPOINT 6-sensor core probe
The oven is equipped with a MULTIPOINT core probe with 6
sensors along the entire stem, for correctly measuring the product
core temperature even if the tip is not completely in the centre.
- Close the door and press the START button.
2) Stopping the cycle. When the required product core tempe-
rature is reached the oven stops automatically and the elapsed
cooking cycle time is displayed.
3) Core probe mode deactivation. Set a cooking time on the
Timer . This action automatically cuts out the core probe,
whereas it is the opposite when the time is set.
The core probe mode is also deactivated when the oven is
switched off.
A
B
4.3.8 END OF COOKING
At the end of the set time, the cooking cycle automatically stops
and the oven buzzer sounds continuously.
The display shows the message:
COOKING FINISHED !
Several parameters such as the following are also displayed:
- total time
- FSC a bar with relevant result will appear if set.
Open the door and remove the product.
Attention! Risk of burns.
Always open the door with caution when the oven is hot.
Notes:
- The buzzer can be stopped in advance by carrying out any
operation on the control panel or by opening the door.
The cooking cycled can be manually stopped by keeping
the STOP button pressed for a few seconds.
A cycle identical to that just completed can be repeated by
pressing the START button again.
26
