Safety Devices; Operation Check; Servicing; Troubleshooting - Electrolux 6 GN 1/1 Installation, Utilisation Et Entretien

USA
in which water might collect (minimum gradient 5%).
WARING: BLOCKING THE DRAIN IS HAZARDOUS.
Important:
- Do not obstruct the safety outlet C1.
- Do not connect the safety outlet C1 to the drainage system.
Note:
If water comes out of the AIR-BREAK (safety outlet C1) this means
the drain C is blocked. Any elimination of the obstruction must be
carried out by specialised technical personnel.

5. SAFETY DEVICES

The appliance is fi tted with the following safety devices:
- Fuses (see electrical circuit diagram) located behind the control
panel.
To change a fuse unscrew and remove the retainer cap and
replace the blown fuse with an identically rated component; the
fuse rating value is specifi ed on the relative dataplate.
- Oven chamber safety thermostat with manual reset, located
behind the control panel; when this device trips, convection heat-
ing power is disconnected.
Notice: CONTACT YOUR AUTHORIZED SERVICE COMPANY
TO PERFORM MANINTENANCE AND REPAIRS.
- Automatic reset thermal protection inside the cavity fan mo-
tor: this device trips in the event of overheating of the cavity fan
motor; this cut-out protects the appliance by disconnecting the
power supply to the main PC board and an error message is
display EFUN.

6. OPERATION CHECK

- Switch on the appliance in accordance with the following section
"Instructions for use".
- With the aid of the Instruction Booklet, explain operation,
routine maintenance, and cleaning to the user.
Attention:
- During operation, pay
attention to the hot areas of the exterior surface.
- Do not place objects on the outlets located at the top of the
appliance.

7. SERVICING

All components requiring routine maintenance may be easily
reached by opening the control panel, removing the left side
panel, or removing the rear panel.
C - Oven drain
Danger: Live voltage is present with panels removed and unit
C1 - Safety outlet
switch on. Exercise extreme caution when work with live voltage.
NOTICE: Using any parts other than OEM original spare parts
relieves the manufacturer of all warranty and liability.

8. TROUBLESHOOTING

Malfunctions may occur even when the appliance is used correctly.
Oven chamber heating not started or ineffi cient. Possible
causes:
- Oven chamber temperature limit switch tripped
- Damaged heating elements
- Damaged heating element contactor coil
- Damaged thermostat probe showing error "EPt1".
- Damaged controller
- Fuse "F2" blown, see circuit diagram.
Steam production not started or ineffi cient.
Possible causes:
- Damaged heating elements
- Damaged heating element contactor coil
- Damaged controller
- Fuse "F2" blown
- No mains water supply
- Faulty boiler drainage outlet closing device
- Damaged water inlet solenoid valves (do not open)
Oven chamber temperature reading incorrect
Possible causes:
- Damaged electronic controller
- Thermostat probe damaged, dirty or interrupted, see error
"EPt1".
Oven switches off
Possible cause:
- Fuse "F2" has blown due to damage of control circuit
components.
Oven chamber lamp fault
WARNING: Switch off the appliance before changing oven
chamber lamps.

9. LAYOUT OF MAIN COMPONENTS

(Any operation inside the appliance must only be carried out
by an installer authorised by the Manufacturer).
Removing the control panel provides access to the following
components:
- Electronic circuit boards
- Oven chamber temperature limit thermostat
- Fuses
- Door microswitch
- Oven chamber lamp transformer
- Geared motor for the oven chamber pressure relief butterfl y
valve.
To gain access to all other components remove the appliance's
left and rear side panels.
16