Electrolux 6 GN 1/1 Installation, Utilisation Et Entretien page 21

Fast compartment cooling: useful for going from one
type of cooking to another at lower temperature; it
enables fan rotation and automatic injection of water
(TS < 356°F)(180°C) even with the door open.
Attention! Risk of burns.
Always open the door with caution when
the oven is hot.
Continuous cooking: the cooking time is endless,
therefore it is necessary to press STOP when the
food is cooked.
MM:MINUTES and SS:SECONDS for short cooking
cycles. Converts minutes into seconds and the letter S
appears next to the number in the bar as an indicator
INFORMATION - NOTES - WARNINGS
Warning light signalling oven door open.
Scale indicator: when this light comes on, the steam
generator must be descaled. Follow the instructions
given in par. 7.
Steam generator status light:
- generator in fi lling phase or no water. Make sure
water reaches the oven!
- generator in preheating phase.
- generator ready (indicator light off).
burner off
Error
Attention
Information
Queries
UTILITIES
Manual injection of water in compartment: for instantly incre-
asing the humidity level during a cooking cycle. Use the + and
- buttons to adjust the injection duration in seconds (10 s intervals).
Low power cycle (heating): for gentle baking, such as light
patisserie. Combinable with all cycles.
FSC- FOODSAFE CONTROL commands.
The FOODSAFE CONTROL is a system allowing the control of
Information area
Area displaying current
cooking in safe food conditions.
Status, Error, Warning
and Utility information.
FSC- The FOODSAFE CONTROL had positive results, cooking
occurred in safe conditions
MULTIPHASE
19
Low speed cycle (fan): for gentle baking,
such as light patisserie. Combinable with all
cycles.
Pulsed speed cycle (fan): for low tempera-
ture cooking. Combinable with all cycles.
Normal speed cycle (fan): for normal cooking.
Combinable with all cycles. (Default setting)
Save Program
Cooking with phases in sequence: for setting cooking
programs with several phases in automatic sequence
(max. 15 phases).
Pause phase: by entering a time value in this mode
it is possible to delay the start of cooking programs
or include a pause between two cycles (e.g. proving).
Add pause phase: see multiphase section.
USA