Yamaha EF2000iS Manuel D'atelier page 302

1 Coupler bracket of generator lead wire
2 Generator assembly
3 Generator fan
4 Rear end cover
5 Generator grommet
6 Protecting tube
7 Plastic locking tie
WIRE ROUTING DIAGRAM
å Install the bracket as shown.
∫ Insert the protecting tube only after passing the
coupler through the rear end cover hole.
ç Plastic locking tie fixing position: Push the protect-
ing tube against the core side.
∂ Secure the protecting tube with the plastic locking
tie after winding it around.
7-19
SPEC