Table des Matières
Publicité
2
1
1
LT
SKI ADJUSTMENT
Toe-out
1. Place the snowmobile on a level surface.
2. Measure:
NOTE:
Point the skis in parallel to the direction of move-
ment.
3. Adjust:
Adjustment steps:
• Remove the shroud. Refer to "SHROUD AND
2
• Loosen the locknuts (tie-rods) 1.
• Turn the tie rods 2 in or out until the specified
• Tighten the locknuts (tie-rods) 1.
1
LT
After tightening the inside and outside ball joint
locknuts 1, make sure the tie rods 2 can be
rotated freely through the ball joint travel. If not,
loosen the locknuts 1 and reposition the ball
joint so that the tie rods 2 can be rotated freely.
Tighten the locknuts to specification.
3-18
• Ski toe-out (a - c)
• Ski stance b
Point the skis forward.
Out of specification → Adjust.
Ski toe-out:
0 ~ 15 mm (0 ~ 0.59 in)
Ski stance (center to center):
FX10/FX10RT/FX10RTR/FX10RTRA
1,050 mm (41.3 in)
FX10MT/FX10MTR/FX10MTRA
980 mm (38.6 in)
• Ski toe-out
COVERS"
toe-out is obtained.
Locknut (rod end):
25 Nm (2.5 m · kg, 18 ft · lb)
®
LOCTITE
CAUTION:
Publicité
Table des Matières
