Drive Chain Housing Oil Level Check - Yamaha FX10X Notice D'assemblage

1
È
É

DRIVE CHAIN HOUSING OIL LEVEL CHECK

1. Remove the shroud and the right side cover.
Refer to "SHROUD AND COVERS"
2. Place the snowmobile on a level surface.
NOTE:
Be sure the snowmobile is positioned straight up
when checking the oil level.
3. Remove the dipstick 1 and wipe it off with a
clean rag, and then screw it back into the filler
hole.
4. Remove the dipstick and check that the oil level
is within the range shown at the bottom of the
dipstick. If the oil does not reach the bottom of
the dipstick, add sufficient oil of the recom-
mended type to raise it to the correct level.
È FX10RT/FX10MT
É FX10/FX10RTR/FX10RTRA/FX10MTR/FX10MTRA
Recommended drive chain housing
oil:
Gear oil "GL-3"
75W or 80W
Oil capacity:
0.20 L (0.18 Imp qt, 0.21 US qt)
CAUTION:
Be sure no foreign material enters the drive
chain housing.
5. Install the dipstick 1.
6. Install the right side cover and the shroud.
Refer to "SHROUD AND COVERS"
3-10