Preparation - Yamaha FX10X Notice D'assemblage

FOREWORD
This Assembly Manual contains the information
required for reassembly of the Yamaha Snowmo-
bile correctly prior to delivery to the customer.
Since some external parts of the snowmobile have
been removed at the Yamaha factory for conve-
nience of packing, assembly by the Yamaha dealer
is required. It should be noted that the reassembled
snowmobile should
inspected, and adjusted prior to delivery to the pur-
chaser.
NOTICE
The service specifications presented in this manual
may become outdated due to future changes in this
model. Yamaha dealers will be notified of these
changes through technical service information that
will be published by Yamaha.
Particularly important information is distinguished in
this manual by the following notations.
The Safety Alert Symbol means ATTENTION!
BECOME ALERT! YOUR SAFETY IS INVOLVED!
WARNING
Failure to follow WARNING instructions could result
in severe injury or death to the snowmobile opera-
tor, a bystander, or a person inspecting or repairing
the snowmobile.
CAUTION:
A CAUTION indicates special precautions that
must be taken to avoid damage to the snowmobile.
NOTE:
A NOTE provides key information to make proce-
dures easier or clearer.
UNPACKING
Note on transportation
Take care not to put the snowmobile packed in the
crate against a hard object or subject it to heavy
shocks during transportation or in the service shop.
be thoroughly cleaned,

PREPARATION

To assemble the snowmobile correctly, supplies
and working space are required:
Supplies
Oils, greases, shop rags.
Workshop
The workshop where the snowmobile is assembled
should be clean and large. The floor should be
level.
Self-protection
Protect your eyes with suitable safety spectacles or
safety goggles when using compressed air, when
grinding or when doing any operation which may
cause particles to fly off.
Protect hands and feet by wearing safety gloves or
protective shoes if appropriate to the work you are
doing.
Procedure for unpacking
1. To remove the snowmobile and parts packed in
the crate, cut the vinyl bands around the carton
using a cutter or scissors. Next, remove the
plastic cover by lifting it straight up.
2. Remove the bolts from each corner of the rack,
and remove the struts.
3. Remove the snowmobile from the crate bottom.
4. Before starting the assembly, check for dam-
aged or missing parts. The parts are contained
in the carton and the vinyl bags in the package.
Also check the snowmobile for damage,
scratches and other defects.
FX10X, FX10RTX, FX10RTRX, FX10RTRAX,
FX10MTX, FX10MTRX, FX10MTRAX
ASSEMBLY MANUAL
© 2007 by Yamaha Motor Co., Ltd.
1st Edition, May 2007
All rights reserved. Any reprinting or
unauthorized use without the written
permission of Yamaha Motor Co., Ltd.
is expressly prohibited.