Table des Matières
Publicité
È
É
3. Adjust:
• Track deflection
Adjustment steps:
• Lift the rear of the snowmobile onto a suitable
stand to raise the track off the ground.
• Loosen the rear axle nut 1.
a. Start the engine and rotate the track one or two
turns. Stop the engine.
b. Check the track alignment with the slide runner
2.
If the alignment is incorrect, turn the left and
right adjusters to adjust.
Track alignment
3 Left adjuster nut
4 Right adjuster nut
5 Slide runner
6 Track
7 Track metal
a Gap
Ê Forward
c. Adjust the track deflection until the specified
amount is obtained.
Track deflection
3 Left adjuster nut
4 Right adjuster nut
CAUTION:
The adjusters should be turned an equal
amount.
• Recheck alignment and deflection. If necessary,
repeat steps "a" to "c" until proper adjustment is
achieved.
• Tighten the rear axle nut.
Rear axle nut:
75 Nm (7.5 m · kg, 54 ft · lb)
3-15
È
É
Shifted to
Shifted to
right
left
Turn out
Turn in
Turn in
Turn out
More than
Less than
Specified
Specified
Turn in
Turn out
Turn in
Turn out
Publicité
Table des Matières
