Table des Matières
Publicité
È
Air bleeding steps:
NOTE:
1
For
FX10MTRA, skip the first three steps.
• Remove the cap 1 on the heat exchanger joint
• While slowly adding coolant to the radiator filler,
• Install the cap 1.
• Add coolant to the full level a.
• Install the radiator cap.
È FX10MT/FX10MTR/FX10MTRA
To avoid severe injury or death:
• Make sure the snowmobile is securely sup-
• Do not exceed the clutch engagement speed.
• Operate the engine only in a well-ventilated
• Remove the radiator cap and bleed the cooling
• Check the coolant level in the coolant reservoir
c
b
3-9
models
other
than
pipe.
drain the coolant until no more air bubbles
appear.
Apply and lock the parking brake. Start the
engine and run it at less than the clutch engage-
ment speed until the coolant circulates (approxi-
mately 3 ~ 5 minutes). The heat exchanger will
be warm to the touch (FX10MT/FX10MTR/
FX10MTRA).
WARNING
ported with a suitable stand.
Drive line damage and excessive V-belt wear
could occur, or the snowmobile could unex-
pectedly move forward if the clutch engages.
area.
system again, as described above.
No air bubbles → OK.
when the engine is cold. If the coolant level is
below the "LOW" mark b add coolant until it
reaches the "FULL" mark c.
FX10MT/FX10MTR/
Publicité
Table des Matières
