Table des Matières
Publicité
2
1
3
4
2. Measure:
• Sheave offset a
Use a straightedge that is approximately
500 mm (19.7 in) long, 20 mm (0.79 in) wide,
and 4 mm (0.16 in) thick.
Out of specification → Adjust.
Sheave offset:
13.5 ~ 16.5 mm (0.53 ~ 0.65 in)
NOTE:
Push the secondary sheave inward towards the
frame, and then measure the sheave offset.
3. Adjust:
• Sheave offset
Adjustment steps:
• Apply the brake to lock the secondary sheave.
• Remove the secondary sheave bolt 1, washer
2, shim(s) (left), and secondary sheave 3.
• Install the appropriate shim(s) (right) 4 from the
following table so that the sheave offset is within
specification.
Shim size
Part number
90201-286K9
• Install
the
secondary
sheave bolt and washer.
Secondary sheave bolt:
64 Nm (6.4 m · kg, 46 ft · lb)
• Recheck the sheave offset. If out of specifica-
tion, repeat the above steps.
3-2
Thickness
1.0 mm (0.04 in)
sheave,
secondary
Publicité
Table des Matières
