Table des Matières
Publicité
NOTE:
Do not lose the strip of caps because it will be used
as battery plugs.
CAUTION:
Do not peel or pierce the sealed areas.
e. Turn the electrolyte container upside-down with
the six sealed areas in line with the six filler
ports of the battery.
f. Push the container down strongly enough to
break the seals. The electrolyte will start to flow
into the battery.
CAUTION:
• Do not tilt the container as the electrolyte may
stop flowing.
• Never remove the container from the battery
until all electrolyte has drained from the con-
tainer.
g. Leave the container in this position for 20 min-
utes or longer to allow proper chemical reaction.
NOTE:
• Make sure air bubbles are rising from all six filler
ports.
• If air bubbles are not rising from a filler port, tap
the top of the container a few times.
h. Be certain that all the electrolyte has been
drained from container.
i. Fit the strip of caps (battery plugs) securely into
the filler ports. Make sure the top of the strip is
at the same level as the top of the battery.
5 Press down horizontally with both hands.
CAUTION:
Never remove the strip of caps, nor add any
water or electrolyte.
3-36
Publicité
Table des Matières
