Publicité
To bring the non-jammed iBOTs home, click the Home button on the Run
screen. All the non-jammed iBOTs will try to get back home. Please be patient
since this may take a little while. It is possible that some iBOTs may not be
jammed but are still unable to get home.
Any iBOT removed from the machine because of a collision can be
reintroduced into the machine at a suitable time.
iBOT Conveyor Stall
Description
This jam occurs when an iBOT cannot detect any movement in
its conveyor, despite attempts to run the conveyor motor.
Resolution
Use the iBOTs status display (in the iBOTs tab in the Run
screen) to identify the location of the jammed iBOT, and find it in the machine.
Check if there is anything obstructing the movement of its conveyor, like the
wedged piece shown in the picture. Remove any obstruction, and then click the
Clear Jam button in the Run screen. Click Start to continue running.
Figure 137: Conveyor stopped by wedged mail
157
Mail Matrix Operator Manual
OPEX Corporation
Publicité
Chapitres
