Publicité
Unknown Bin
Location
Unknown Reject
Reason
Unable to Read
Document
Keyer Rejected
Piece
Too Skewed to
Label
Failed to Label
Label Verification
Failed
Document Too
Skewed
Document Size
Incorrect
Sort Information Not
Available
Printer Data Error
Abandoned at End
of Job
ELC Requested
Reject
The DestinationId field value in the database does not
exist in the current bin configuration.
Results when the host has decided to send a piece to
the reject bin but has not assigned a reject reason.
MLOCR/DRS failed to resolve the piece when running
in 'No Keyer' mode.
The keyer used the Undo button to reject a piece
before it was delivered.
Results when the skew sensor has detected a piece
to be too skewed to label.
Results when a jam interrupts the labeling process
preventing labeling from completing.
Results when the verifier is unable to match the
verification string expected to be found within a
barcode on the label.
Results when skew detection has determined that the
piece is skewed outside the boundaries specified in
the system setup.
Results when the length and/or height measurement
does not match the expected length and/or height.
Results when the host has no knowledge about a
certain piece, and cannot make a sort decision.
A piece needs to be labeled, but error(s) in generating
printer data or sending it to the printer cause this
reject.
The operator decided to quit a job when the machine
was jammed, and pieces were left undelivered inside
the machine. When the system starts up again, these
pieces are delivered to the Reject bin and counted as
Abandoned at End of Job rejects.
An External Link Component (ELC) requested that the
piece be rejected.
Mail Matrix Operator Manual
OPEX Corporation
139
Publicité
Chapitres
