Publicité
8. When the iBOT reaches the label application point, the label applicator pad
is forced down against the envelope, applying the label.
9. After applying the label, the labeler arm retracts, so that it is ready to pick
up the next label.
10. The verifier scanner then captures an image of the label to confirm that the
label is present. If no label is present, the iBOT will move the piece to the
reject bin.
11. If the label is present, the iBOT moves the mail piece to the assigned bin.
A flow diagram of the printing-labeling process is shown below.
Hand drop
piece
START
or
Auto feed
piece
Move piece to
END
assigned bin
OCR / DRS
bin lookup
Image
Piece loaded
capture
on iBot
No
Label
Yes
verified?
Figure 87: Printing-labeling process
Mail Matrix Operator Manual
OPEX Corporation
No
Print label &
Bin
Yes
load onto
assigned?
label pad
Move iBot to
Piece
Piece Detect
detected? Yes
Position
No
Move piece
to reject bin
Retract
Scan label &
labeler
verify
arm
Extend
labeler
arm
Move iBOT to
label point
iBot at
No
label point?
Yes
Apply label
105
Publicité
Chapitres
