Publicité
Feeder Section E-Stop Pressed
Description
This jam occurs if the E-Stop switch in the Auto-Feeder section
(indicated below) has been pressed.
Resolution
E-Stop switches enable a quick stop of all motors in the machine
in the event of an emergency involving potential personnel injury. Check to
ensure that it is safe to run the machine. To reset the E-Stop, twist the E-Stop
knob clockwise. The machine can be restarted now by clicking the Start
button on the Run screen.
Host-Controller Communication Failure
Description
This error occurs when the communications between the PC
and the Real-Time Controller have stopped.
Resolution
Exit out of the Mail Matrix software, wait for about 15 seconds,
and then restart the Mail Matrix application. Attempt to start the job as normal.
If communication with the Controller is still not working, the job will not start,
and a message indicating communication failure will be displayed. Call OPEX
service in that case.
152
Figure 132: E-Stop location
Mail Matrix Operator Manual
OPEX Corporation
Publicité
Chapitres
