Chapter 6: Accessories And Options; Spindle Fittings For Mounting Helicoidal Drills; Transport/Protection Box; Utilisation For Grooved Rails - GEISMAR PR.2 Notice Originale

6.1 Spindle fittings for mounting helicoidal drills

A spindle end ① with a Weldon attachment can be fitted to the machine to allow the use of helicoidal drills ③.
The drill is held in the spindle end by a flat-ended screw ②.
Helicoidal drill adapter ①
Screw ② (Ref. KLX)
Helicoidal drill ③

6.2 Transport/protection box

The transport box (Ref. MAL) protects the machine during transport and
storage, together with the pressurised tank and accessories case (Ref.
LZL). All items have a dedicated position for maximum support and
protection.

6.3 Utilisation for grooved rails

The machine can be used on grooved rails.
For drilling a rail on the groove side (see Fig.1):
Special clamping pieces ④ must be used (complete as fully as possible the
document shown in Appendix A).
For drilling a rail on the side opposite the groove (see Fig.2):
Special clamping pieces ④ must be used, together with spacers ⑤ (Ref.
11294 or 11294 A or 11294 B depending on design) (complete as fully as
possible the document shown in Appendix A).
6.1

CHAPTER 6: ACCESSORIES AND OPTIONS

(Ref. 73058 B for drill Ø 7 mm)
(Ref. 73058 for drill Ø 8 mm).
(Ref. 73058 D for drill Ø 9.8 mm).
(Ref. 73058 C for drill Ø 12 mm).
(Ref. 73058 A for drill Ø 13.5 mm).
(Ref. 73058-7 for drill Ø 7 mm)
.
(Ref. 73058-8 for drill Ø 8 mm).
(Ref. 73058-9.8 for drill Ø 9.8 mm).
(Ref. 73058-12 for drill Ø 12 mm).
(Ref. 73058-13.5 for drill Ø 13.5 mm).
.
4
Drilling groove side
PR2_Gb_00989_120314.doc
2
1
4
Fig.1
Drilling on side opposite groove
3
5
Fig.2
6.3