Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• The operator and the machine
Before putting the machine into service each time, check that its condition and its operation are in compliance with the instructions.
In particular, make sure that the controls are free and in good working order, and that they are in the "stop" or "neutral" position. Never make any
modifications that could affect correct operation of the control systems.
All the protective elements must be kept carefully in place and in good condition.
Always keep the machine clean and remove any accumulated dust, especially if it could absorb flammable products.
Always move forwards when working.
When working, always hold the machine with both hands to ensure control at all times, and to be able to use it in full safety.
Never bring a machine close to a flame or a source of heat.
The machine must never be positioned close to hot or protruding elements that could damage some parts (tanks, exhaust, housings...).
Never move away from a machine while the engine is running, even when it is idling. Stop the engine immediately if the machine is not in use. After
stopping the engine, wait until all moving parts have come to a complete stop.
Work on the electrical installations on the machine can only be carried out by suitably qualified persons.
Read and make sure you fully understand all the signs placed on the machine, and always comply with all the instructions.
The signs placed on the machine include pictograms, manufacturer's plates, and instruction labels. Make sure they are kept clean and replaced if
they have been damaged, or if they are missing or illegible. If one of these elements is on a part that is to be replaced, a new element must be present
on the replacement part. Please contact us on this subject.
When using a lifting device, the lifting operations of the machine must be done only using the lifting points indicated on the instruction manual.
When possible, the lifting of the machine is to be done only when the machine needs to be set in or out of the track. If the machine has to stay lifted
(for a maintenance operation for example), the hazardous area must be signaled/marked, so that no one can stay below the machine or walk close by.
THE MACHINE MUST NEVER BE USED FOR A PURPOSE OTHER THAN THAT FOR WHICH IT IS INTENDED
NEVER TOUCH A MOVING PART WITH A TOOL
IT IS
E
E
S
S
S
S
E
E
N
N
T
T
I
I
A
A
L
L
-
ANY HANDLING WORK
-
ANY WORK TO CHANGE TOOLS OR SOCKETS
-
ANY WORK INVOLVING FUEL OR OIL
-
ANY REPAIR
1.3
T
T
O
O
S
S
T
T
O
O
P
P
T
T
H
H
E
E
E
E
N
N
G
G
I
I
N
N
E AND SET THE CONTROL TO THE STOP POSITION BEFORE CARRYING OUT
E
,
MAINTENANCE OR CLEANING WORK
,
,
OR WITH THE HAND
OR WITH ANY OTHER PART OF THE BODY
(
,
,
FILLING
TOPPING UP
CHECKING LEVELS
SECT_Gb_00005_110202.doc
:
,
.)
ETC
1.3
Publicité
Chapitres
Table des Matières
