Fitting Taper Clamps - GEISMAR PR.2 Notice Originale

Perceuse de rails ultra legere
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.4 Fitting taper clamps

Taper clamps position the machine automatically at the correct height for rail drilling.
Each type of rail and drilling height requires a specific taper clamp.
The PRZ uses single or double taper clamps. Each of the two taper clamps has its own dedicated position (right or left) and they must not be reversed. An
error-proof device protects against this. Clamp markings are always on the outside (on the visible side).
67051xx → left single taper clamp
Marking:
67052xx → right single taper clamp
67044xx → left double taper clamp
Marking:
67045xx → right double taper clamp
• To fit taper clamps (single or double), proceed as follows:
-
Engage the taper clamp ① on the locating pins .
- Securely tighten the fixing screw ③.
-
Proceed in the same way for 2
NB - When ordering taper clamps, you need to tell us the
type of rail and the type of machine. Complete as fully as
possible the document shown in Appendix A.
3.4
nd
clamp.
PRZ_Gb_00955_110725.doc
1
2
3
3.4

Publicité

Chapitres

Table des Matières
loading

Table des Matières