GROLAB USERBOT HW01 Manuel D'installation page 6

Before connec ng the UserBot shield to the
EN
Arduino, make sure the Arduino is correctly
assembled and ready to be used (follow the
ES
official Arduino instruc ons manual). Also,
FR
make sure your Arduino is not connected to
the power supply.
PT
Place the Arduino on a firm surface, far from
IT
flood-prone areas. Make sure the Arduino
female pin headers (A1) are faced up and the
UserBot shield connec on pins (7) are faced
down.
A2
Insert the UserBot connec on pins (7) into the
Arduino female header (A1) from top-down as
shown in the above picture.
Avoid the contact between the UserBot shield and the
Arduino USB power entry (A2).
5
7
A1
5