GROLAB USERBOT HW01 Manuel D'installation page 28

COMMUNICATIONS
EN
ES
Connec on to GroNode
FR
Make sure the GroNode is correctly installed
PT
and accessible through the GroLab So ware. If
not, follow the instruc ons provided inside the
IT
GroNode's manual.
A er comple ng all the UserBot shield installa-
on steps, open the GroLab So ware, establi-
sh a connec on with the GroNode and then,
access Modules through the main menu.
Usually, 2 or 3 minutes are enough for GroNo-
de to detect a newly installed module. Once it
is detected, it will automa cally appear in the
Modules menu under the respec ve module
type sec on.
You can check the list of modules of the same
type on the right side of this menu. Note that
one GroNode supports a maximum of 4 modu-
les of each type.
27
2