GROLAB USERBOT HW01 Manuel D'installation page 20

If you need to change the cases from the
EN
switch it is also required to change the enum
that contains those cases. The enum is decla-
ES
red in the SensorsTask.h (
FR
OpenGrow
PT
At this point, the code is prepared to handle
IT
the physical peripherals from the diagram
shown in example 1. Now it is me to compi-
le and upload the code to your Arduino.
If you need assistance to compile and upload
the code, please refer to the official Arduino
guides or contact the Arduino support center.
A er uploading the code to your Arduino,
there is s ll one step required to make it fully
opera onal and ready to communicate with
GroLab system: the factory se ngs need to
be set (serial number and communica on
channel). Please refer to the instruc ons on
pages 25 and 26.
19 9
).
UserBot
→
examples
→