GROLAB USERBOT HW01 Manuel D'installation page 16

Example 1
EN
Connec ng one bu on, one temperature sensor, and one LED.
ES
To interface the bu on, the temperature
sensor and the LED, open the UserBot.ino
FR
(
examples
PT
te to the setup func on. This func on
contains the configura on for all the inputs
IT
and outputs. You should adjust the code to
match the electronics you assembled on the
board. For the example diagram, the code
should be the following:
INPUTS CONFIGURATION
15 5
OpenGrow
→
) and naviga-
UserBot
→
15